Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Mon Jun 29 19:36:08 EDT 2009 | proy
Are you sure it is the Z axis, and not the rotation, I had one machine which often did something similar, it would buzz loudly, especially if you touched or applied rotation pressure to the gear belt which rotates the head. It never caused any hard s
Electronics Forum | Thu Jul 09 12:47:09 EDT 2009 | janz
Hello, We are using F4G software for our Fuji machines. We've 5 machines plug into PC. Recently we tried to connect PC to local network but this only after while close C/C server without possibility to reopen C/C server. Reseting PC gives C/C lice
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Mon Jul 27 20:35:40 EDT 2009 | michaellaw
Just curious if anyone here has experience with a > Panasert RH6 Radial Insertion machine. Ours is > having some problems detecting insertion, appears > to be failing to sense when the legs are cut and > is triggering the error. This is the com
Electronics Forum | Tue Aug 25 08:46:03 EDT 2009 | doremiking
I've just seen your question because I list this site rarely. It can boot usually from C: hard drive, we have 4 Omron AOIs - brand new (RNS & VT-WIN2),theoretically one computer can boot from different disks, it is set up in the BIOS, there are some
Electronics Forum | Sun Aug 02 21:59:37 EDT 2009 | hohk
Wow! Thanks Jim!. When the ejector pin hits the piezo ceramic sensor, the sensor will produce a voltage difference between the top and bottom surface(that's why i need to connect the tracks on both sides) which i will measure. The sensor does not ne
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Thu Aug 13 15:16:16 EDT 2009 | davef
BoardHouse: You mean that our 'Martin Gershenson' might be this guy? Martin Gershenson; Christopher Associates Inc.,3617 W. MacArthur Blvd.Santa Ana, CA 92704; 714–979-7500 martin.gershenson@christopherweb.com So, you're implying that unlike some
