Electronics Forum | Tue Mar 01 23:55:41 EST 2011 | cmguan79
Hi all, Need help troubleshooting for I've just bought a 1997 second-hand oven HVC102. Unfortunately, after loading profile & press run mode we found all TC READING IS ZERO & CONVEYOR READING FEEDBACK IS ZERO SHOWN ON MONITOR SCREEN ,& I LOSS PA
Electronics Forum | Thu Mar 17 10:06:09 EDT 2011 | dyoungquist
Strange indeed. We use a Q18 and have never seen this. Is it sweating inside the thermal barrier case, i.e. you put it in the case dry and it is wet when you take it out of the case? Maybe its actually coming from the inside of your thermal barrie
Electronics Forum | Fri Mar 18 13:42:02 EDT 2011 | kahrpr
First thing try a different solder paste. All solder pastes are not created equal. Also if everything else on the board looks good then check the part. As far as nitrogen goes its about 4 bucket loads you need an external tank. I have seen some marg
Electronics Forum | Sun Mar 20 12:58:23 EDT 2011 | sellenzz
We have a Nitrogen Silo. Your going to want to be careful if you decide to use nitrogen, not only are the levels unstable most of the time but it can also cause your components to tombstone like crazy, especially if you run a lot of LED's. We run 24/
Electronics Forum | Thu Mar 31 20:16:31 EDT 2011 | tkirk
We recently decided to try using a different source for our bare boards to save money. On two different batches of PCBs now from the new source, we are seeing beading including some serious enough to short out underneath 0805 parts. We have never re
Electronics Forum | Tue Apr 05 14:42:41 EDT 2011 | clampron
Bigvern, We have had the same problem on two different occasions. Both issues were caused by the vacuum sensor. The first time this happened, we had a tech from Dage in to repair. This was fairly costly. When it happened again, we opened the cabinet
Electronics Forum | Fri Apr 08 06:12:06 EDT 2011 | don7888
Thanks Reese. To be honest I don't know a great deal about the software just yet but we are running version 2.7.4. I know the guys are saying that they have a problem with identifying small capacitors and resistors as these have no markings though t
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
Electronics Forum | Wed May 11 14:34:03 EDT 2011 | thejedeye
Google, Documents, spread sheet, public access. Or try a DropBox account. This is an invite link. http://db.tt/5UBwDPV NOTE:FYI:if you use the link and join I get 250 Mb more storage. There are other types like it out there, a customer has such
Electronics Forum | Tue Apr 19 10:19:28 EDT 2011 | leemeyer
We currently have a job that uses press fit solderless pins. The pins are custom and only supplied in bulk packaging. I am looking for a machine that can orient the pins and present them to my insertion machine. Of course i need the pin to be present
