Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
Electronics Forum | Fri Feb 21 10:59:15 EST 2020 | slthomas
I used to work for an OEM that made professional audio equipment (studio monitors, mixing boards, etc.). The mixers required precise alignment of LEDs, switches, and pots in the sheet metal so we used aluminum alignment fixtures during wave solder. T
Electronics Forum | Wed Aug 11 12:41:05 EDT 2021 | jamesatqkits
Hi Bukas, Thanks for getting back to me. What is the IF board? Is that the Interface Boards in the cage? How do I know if I have a healthy hard drive? Is there anything in particular to look for? I will run chkdsk today and see if it reports any
Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
Electronics Forum | Wed Mar 18 11:27:24 EDT 2020 | slthomas
I am about to order a stencil and I can already see that I'm going to have issues. I'm hoping someone has a recipe for this scenario that we haven't tried yet. The parts are 16 mil pitch bga's, the pads are NSMD (10 mil dia. with 12.6 mil mask open
Electronics Forum | Sun Mar 29 14:17:03 EDT 2020 | midast
Hi We have a MY 19 that just reboots the computer. It is like some just unplugged the power. We have nothing in the logs. All I see is when it starts up again. The problem can happen anytime. Today I found that it always happens when I try to auto
Electronics Forum | Wed May 06 18:15:03 EDT 2020 | travishemen
I thought i posted this last night. The easiest way I can think of to see what nozzle is being used is to put the machine in step mode and do one part at a time. Also the levelness of the table and Z0 could be suspect. On a CP643 this can get out
Electronics Forum | Fri May 15 11:59:05 EDT 2020 | stephendo
There are a couple of other countries that should be on your list to considered in at least some circumstances. Canada and The United States. I work for a CEM in Toronto, at the end of last year before all this, we had a largish job for a customer i