Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Tue Jun 13 14:16:54 EDT 2017 | dekhead
Thanks, I try. But enable codes on Micron class not something I can accomplish. DEKHEAD
Electronics Forum | Wed Apr 26 22:59:46 EDT 2017 | navworx
Great posting. We're looking at AOI for the first time and are trying to understand the pros/cons of 2D, 2D+, and 3D. M, can you discuss what size parts are too small for the Mirtec MV-3L?
Electronics Forum | Thu Nov 05 00:11:11 EST 2009 | shinseimy
Hi, You might be can consider try our brand AOI checker. We are the manufacturer the AOI which located at Malaysia. The programming is very easy to use, and effective on the speed. Furthermore, 2D barcode reader, NG marking included. If you are inte
Electronics Forum | Mon May 07 09:40:16 EDT 2001 | bphilips
What defects can not be found or are very difficult to find with 2D AOI?
Electronics Forum | Mon May 07 09:36:11 EDT 2001 | marys
In AOI, what advantages does 3D imaging have over 2D imaging?
Electronics Forum | Mon May 07 09:43:22 EDT 2001 | martys
Which AOI imaging method is best for the post-solder stage- 2D or 3D?
Electronics Forum | Wed Oct 09 13:52:17 EDT 2019 | valletta
Hi Aurther, Thanks for a prompt reply. I agree but unfortunately our AOI is 2D and misses a lot of solder defects especially on connector terminals which are surface mount. We are also dependent on operator at AOI to mark the defect if caught by AOI
Electronics Forum | Mon May 07 09:47:11 EDT 2001 | orbotech
All defect types that can not be seen from top view, meaning - any defect which is characterized by more than its top 2D appearance will be hard, if at all possible, to detect by 2D imaging system. This includes: Lifted leads / co planarity J-lead
Electronics Forum | Wed Mar 03 07:29:34 EST 2004 | pjc
2D will give you on-line contrast inspection for paste coverage on the land. I would go with 2D on the printer when comparing to an AOI that will do the same contrast inspection. There are systems out there that will check paste hieght and area cover
