Electronics Forum | Wed Jul 07 11:44:06 EDT 2004 | brownegg
hi, i'm trying to find out what ODM's these 6 companies are using: Dell, HP/Compaq, FSC (Fujitsu Siemens Computer), IBM, APPLE and ACER. is there any kind of record of it on the net. At the moment i'm just going through the search engine and looki
Electronics Forum | Thu Jul 15 07:08:29 EDT 2004 | pcbrown
Basically, it's a tilting problem of certain devices. Usually with axial by-pass caps tilting, which pulls the lead up through it's mounting hole. Other problems with components with leads cut to lenght to eliminate post-wave trimming. All suggestion
Electronics Forum | Mon Jul 19 08:52:02 EDT 2004 | Omega
Try spraying flux on top of the loaded PWB when you put it on the conveyor. The tackiness of the flux does a pretty fair job of keeping the axial leaded parts down to the board. This takes more cleaning, but it has worked wonders for me on assemblies
Electronics Forum | Sat Jul 24 11:13:10 EDT 2004 | Steve
I would contact my local distributor. Using a Heat Gun is not the best method for rework. Using the Air Bath depending on board specifications also may not be the best method. Try a small distributor rather than a catalog house. Usually the small dis
Electronics Forum | Mon Aug 16 13:49:10 EDT 2004 | Paul
You are welcome. I typically just read here and try not to post, but the other post was unfairly negative and seemed to be biased to a single supplier...which I always find suspect. Here are the links to APE and ZEPHYRTRONICS which I hope you find h
Electronics Forum | Mon Jul 26 19:26:06 EDT 2004 | Grant
Hi, Yes, it was quite funny, and everyone thought I was nuts, but it was something worth trying. It's often the weirdest ideas that work. The full tube was ok, but the half full one generated the plasma. That scared the hell out of us when it lit up
Electronics Forum | Mon Dec 20 12:10:39 EST 2004 | Bob Atkinson
You can get the bulbs already mounted in the holder from RoyonicUSA (www.royonicusa.com). They are $79.00, part number 212. If you try to buy a bulb and align it in the holder, you probably won't be successful as the bulbs are factory mounted and a
Electronics Forum | Tue Jul 27 06:08:18 EDT 2004 | C Lampron
Good Morning Everyone, Could someone please tell me what the acceptable range is for HASL plating thickness. We have some raw boards with plating thicknesses ranging from 3-4 mils on a fine pitch QFP. We are expeiencing bridging at this location an
Electronics Forum | Fri Jul 30 11:32:31 EDT 2004 | westred
I am looking for a fool-proof way to have operators measure PCB's out of the depaneler to ensure that the tolerances for the outside edges are being met. Probably a spot check system to make sure the process is in tolerance. So far building a "GO"
Electronics Forum | Sat Jul 31 08:52:15 EDT 2004 | g2garyg2
I am soldering with a softbeam laser and often get a flux/solder build up at the end of the feed tube. Seems better when we use Senju wire but this is very costly. It seems like we have tried everything to resolve this. Would appreciate assistance on