Electronics Forum | Wed Mar 02 04:52:42 EST 2005 | GV
Cookson solder paste 256 seem to be a good and very active no clean solder paste. We have some good experience. We did not bother to evaluate oters since we have had good results with this solder paste. May be you can try. Most important is the reflo
Electronics Forum | Wed Mar 02 09:19:15 EST 2005 | Dilbert
You probably are aware of this, but somehow get the conditioning unit as close to the sensor as you can. It sounds like the problem is the "long twisted pair shielded cable". Try different means of shielding, connect the shield at the end that has
Electronics Forum | Mon Mar 07 11:20:10 EST 2005 | mrduckmann2000
Russ, I tried to get a screen for glue but the design engineer who laid this board out made up his own rules. The 0402 pads are to close for a proper dot size.....per the stencil house. That is why I am going the solder mask route. I would rather
Electronics Forum | Sun Mar 06 11:04:19 EST 2005 | jsk
Slot three will not recognize magazine. LED's are lit (green)when inserted into slot three. Magazine works in all other slots. Tried multiple magazines. All gave the same error. Error code = E-MIPR-1 unknown magazine type slot 3 No visible damage t
Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Wed Mar 16 08:06:52 EST 2005 | zsolt
Grant is right, also for us was the easiest solution to us custom pallets. But you should also try to tweak preheat zones settings. The flux manufacturer should give you some basic temperatures where the flux gets activated. Also it is worth to make
Electronics Forum | Thu Mar 17 15:03:23 EST 2005 | debh
Has anyone ever tried to use "Reel Scan" (brand) barcoding with Juki machines. We currently have 730-2020 and 2050-2060 lines set up. Was wondering how the compatibility is. (I think I already know the 730 is out...) I'll be asking the vendor also, b
Electronics Forum | Sat Mar 26 08:30:01 EST 2005 | davef
Consider this: * SolderQuick Winslow Automation-type [ http://www.winslowautomation.com ] preform * When LGA first came on the scene, we didn't have a clue. After trying sockets, we printed paste on the pads bug-up, reflowed, and then the placed the
Electronics Forum | Mon Mar 21 09:50:29 EST 2005 | davef
It's possible to remove 1mm from each side of the board. Obviously, you need to avoid damaging the board circuitry or the display. If we were going to try this, we'd poke the working end of a Sears router through a hole in the table and fixture a w
Electronics Forum | Tue Mar 22 03:23:10 EST 2005 | EA
Hi, We are trying to break a component ( SMT component ) off the printed circuit board and measure the quality of the solder joint. But, after breaking off and having the reading, we do not know whether the reading is it within the component specifi