Electronics Forum | Mon Jul 20 10:23:29 EDT 1998 | Sherry
Hello friends.... Can someone please point me in the right direction... I will be needing the capability of forming/trimming QFP's on a very low volumn scale in house. So far I've only been able to find one manufacturer and that is Fancort Industri
Electronics Forum | Mon May 14 09:35:21 EDT 2018 | directx995
Hello everyone, A few days ago I design one special kind of PCB for testing accuracy of our Pick and Place machines. (for trimming, calibrating, NPI etc.) I am looking for adhesive spray, to apply it on PCB (at the moment I'm using double sided tape
Electronics Forum | Mon May 14 10:57:08 EDT 2018 | Robl
Hi Ivan, We use a strong double sided tape/sheet. I would be concerned with an adhesive as it would still be curing going through the machines, gassing out vapor. The double sided works OK with our 0201 test board - 16000 placements in rows at 0,9
Electronics Forum | Mon Jul 20 13:28:14 EDT 1998 | Chris Fontaine
We regularly form QFP's and FP's (pitches to 20 mil) and have experience with both Knight and Fancort equipment, however most of our experience has been with Knight. Knight Tool has been consistently good, and I've had some sour experiences with Fan
Electronics Forum | Thu Dec 28 18:59:14 EST 2023 | triplettx3
lead o matic is one we use for trimming leads after wave solder
Electronics Forum | Thu Dec 28 21:28:36 EST 2023 | emeto
What type of PCB? What type of component?..... There are TH components that should not be trimmed at all. Some are sensitive to fractures, other times it is a bad design combination between board design and lead need trimming. Overall try to trim bef
Electronics Forum | Fri Sep 20 11:11:12 EDT 2019 | SMTA-Ernest
Are you interested in trimming pre-solder or post solder? Roto Form Corp. which I believe is located in Tennessee. This machine incorporates a small rotary cutting head for post solder trimming. Otherwise pre-solder trimming is required suggest co
Electronics Forum | Fri Jul 07 16:29:41 EDT 2000 | dstamour
Does anyone know of anybody who makes a device to take Gasfets off of tape and reel trim them to length and present them to the machine (zevatech, juki) for placement. An alternative would be to take them off tape and reel trim them and re tape and r
Electronics Forum | Sun Feb 06 07:49:16 EST 2000 | Dave F
Casimir: A comment and a couple questions: * Have you considered a machine that forms component leads to "self-clinch?" With this forming components snap into hole in the boards with the proper finished lead length and requires not trimming after
Electronics Forum | Tue Jul 13 10:31:16 EDT 2004 | davef
No, experience, but a couple of comments are: * Your 2mm leads are proabably not ment to be trimmed. Consider returning these and buying components with shorter leads. [We know, we know. You have to build this piece of junk right NOW!!!! B-)] * I
