Electronics Forum | Wed Nov 27 20:14:15 EST 2013 | mac5
Evtimov, I have yet to find any ‘good’ belt feeders. If a part is offered only in a tube we send the part out for value added tape and reel. Just make sure you specify the polarity of the part in the reel to your vendor. If that is not an option we
Electronics Forum | Mon Dec 02 15:43:55 EST 2013 | jgarver1
We have Siemens Vibratory Feeders in stock that will allow you to feed components directly from the tube. Let us know if we can help. Jared Garver IBE SMT Equipment www.ibesmt.com
Electronics Forum | Thu Mar 24 10:15:56 EST 2005 | blueflag
Dear All We are using a my12 also tp11 with VIB feeders we are having major problems with ics in tubes are there any machines available to convert ics up to so16 from stick to tape & reel and are the cost effective ?????? Thanks Colin
Electronics Forum | Thu Mar 24 17:36:31 EST 2005 | Grant
Hi, Yes MYDATA vibration feeders are a nightmare, but you might want to check the feeder. We had one that would vary a lot, and it never seemed to be able to be set to the right vibration level for consistent feeding. It turned out to have a problem
Electronics Forum | Thu Mar 24 22:39:22 EST 2005 | pmd
My opertaors have lots of setup problems with vib feeders. They dont realize that the chip weight pushes parts down and when feeders run low it's the frequency that drives the parts. Mixing parts with diferant phisical deminsions and masses in the sa
Electronics Forum | Tue Aug 25 14:34:24 EDT 1998 | D Wanzek
I am looking for advice on feeders for the MPAV Panasonic machine. We are about to encounter our first experience with Panasonic. We are unsure of which style feeders to buy for tube parts. Parts mix includes all sizes of D-paks, SOICs, PLCCs and so
Electronics Forum | Wed Aug 26 07:00:16 EDT 1998 | Wayne Bracy
| I am looking for advice on feeders for the MPAV Panasonic machine. We are about to encounter our first experience with Panasonic. We are unsure of which style feeders to buy for tube parts. Parts mix includes all sizes of D-paks, SOICs, PLCCs and
Electronics Forum | Thu Jan 13 15:12:15 EST 2022 | emeto
Send these parts for tape and reel. This is trhe best solution for tube feeders.
Electronics Forum | Wed Jan 15 07:25:37 EST 2003 | Jean-Philippe
LPMTF means Low Profile Multi-Tube Feeder and EMTF means Extended Multi-Tube Feeder. The difference is that the EMTF is bigger and it supports a wider range of tube.
Electronics Forum | Fri Mar 09 11:16:50 EST 2001 | gsmguru
Try Component Express. They have quite a few tube feeders available. I've used their Multi-Tube feeders for the GSM with success. http://www.c-express.com/
