Electronics Forum | Tue Nov 27 10:56:42 EST 2001 | jmathis
Hello, Our company has been successfully using Loctite 3612 for screen printing glue. Resently there has been a HUGE issue with the melf components falling off or tumbstoning during the wave process. It's apparent that these components were cured
Electronics Forum | Tue Nov 27 19:50:23 EST 2001 | davef
So, which is it �falling off or tumbstoning�? Each has different causes. You say �It's apparent that these components were cured and in place prior to wave solder.� * Cure heat cycle maybe. But is the glue holding? I mean if your cure is real good
| 1 |
winsouce.jpg)
.gif)
