Electronics Forum | Wed Apr 13 04:09:15 EDT 2005 | simmcircuits
Hi, I need help with our MPM UP2000, the stencil and the lamp boards won't turn off completely, they are both on at the same time. Turning it on would only make it brighter, turning it off will just lose the brightness but the lamps are still on. I h
Electronics Forum | Wed Aug 27 16:08:51 EDT 2014 | fuji_user_2014
Alright, thanks for the fast reply
Electronics Forum | Tue Aug 26 09:13:34 EDT 2014 | fuji_user_2014
Thank you, but as I said before, is there a way to do this WITHOUT adding skip marks? We need a global setting that will affect all our existing programs.
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic
Electronics Forum | Wed Aug 27 12:15:15 EDT 2014 | jimmyboz
I understand what you want, I do not however, understand why? I have checked some documentation and found nothing. If I know why, I might try harder for a solution. It doesn't seem like time is crucial, else you want to pre-pick. Two easy ways ar
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Sun Jan 22 12:16:28 EST 2017 | bamproto
Dear Mr. Sang, Have you checked the pick-up position. Could the nozzle descend too much and disturb the other components in the tape?
winsouce.jpg)