Electronics Forum | Wed Aug 26 15:00:08 EDT 2020 | jmelson
That's a rev 1 board, my machine has a rev 2. I have no idea if they are interchangeable. So, I bought a Rev 2 board from Korea. But, I'm flying pretty blind on this. I have traced the ready button signal to a microprocessor pin on the IO_DPRAM bo
Electronics Forum | Wed Jan 30 11:52:51 EST 2013 | mccabekev
We have a Nutek NTM 410L-500-1 sitting between our screen printer and p&p machine. The problem we are having is that this conveyor will constantly show board ready unless the red button is held down. What we really need is the board to stop at the
Electronics Forum | Wed Sep 18 18:40:05 EDT 2002 | dougt
Here is how smema works: Machine A has a board to give to machine B. Machine A has an opto or a relay that will turn on or close when it is ready to pass this board to machine B. This is the "board available from previous" signal, telling machine B
Electronics Forum | Mon Sep 24 20:34:46 EDT 2012 | saduquette
Hi All, I have a Quad 4C that the quadalign processor started acting up on. Where the Hand Held Progrmmer would hang at "Laser Align Init" when you first turn the machine on. A couple of times I was able to get it running by pressing the re
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Fri Feb 27 10:12:36 EST 2004 | stefwitt
The front plate of the S15 head gives you access to the signal amplifier boards. You'll find 4 potentiometers adjusting the voltage and the symmetry of track A and B. A digital scope turned to X+Y provides an image of a circle, which is been adjusted
Electronics Forum | Thu Sep 02 20:41:03 EDT 2010 | mmccance
SME, Thanks for your response, but I have already checked out 1 & 2 on the downstream conveyor, and they are sending the machine ready signal. I know that the loader is recieving it because when the downstream conveyor is not busy the loader attemp
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
.gif)
winsouce.jpg)