Electronics Forum | Thu Apr 28 11:36:13 EDT 2022 | kumarb
It appears to be a female DIN connector. Can you count the # of holes inside this connector ? So far, unable to locate the same mating connector but the picture is not perfectly clear.
Electronics Forum | Thu Apr 28 09:01:38 EDT 2022 | saberbouras
I have a solder paste fridge; my question is what is the type of this connector so I can use it to attach a warning light. And is it a power source or is it a dry contact relay output?
Electronics Forum | Fri Apr 29 17:06:57 EDT 2022 | tey422
Unscrew it, pull it out at least a bit so you can take a better frontal image of it and from the side too. Then you would have better luck to find what connector it is by using the Google Image search
Electronics Forum | Thu Apr 28 11:58:23 EDT 2022 | saberbouras
Thanks it's a 6 pins there is a hole on the bottom but it doesn't seem to be a pin, it's just a hole.
Electronics Forum | Fri Apr 29 17:42:50 EDT 2022 | jdengler
It's either a 6 pin DIN of 6 pin Mini DIN. The diameters are different so check that.
Electronics Forum | Fri Feb 20 17:04:26 EST 2004 | Long
Hi I am looking for some type of peelable mask or plug to cover the connector during the conformal coating. The problem we have is the moisture get into system and eventually penetrate under the connector creating short circuit to the board. What I r
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Sat Nov 09 20:11:43 EST 2019 | richardcargill
I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Wed Apr 09 13:43:12 EDT 2008 | fujillews
Hi Send me a picture with some dimensions directly to llew@alternativesmt.com of fax to our head office i will create one for you f.o.c
