Electronics Forum | Tue Jan 19 04:53:21 EST 2010 | ptxems
The UK office could offer that software, but its not really worth it as it still requires a lot of further input. Think its just going to be a case of reprogramming all the boards!!! You can transfer from 700 to 2000 series, but not 500 to later mo
Electronics Forum | Mon Aug 06 15:54:06 EDT 2001 | Fox
I think that anyone who has any questions about Tyco Electronics' offerings as far as equipment should check out their new web site: automation.tycoelectronics.com One other note about the references to Dynapert equipment and their link to Multitron
Electronics Forum | Fri Oct 01 04:31:08 EDT 2004 | pioneertechnology
Hi Marcel I bought four BTU ovens a couple of years ago at auction and had the same problem where two of the ovens had software and two did not. I loaded in the software I had onto the two ovens and this only partially worked as the software is con
Electronics Forum | Tue Feb 26 04:55:32 EST 2002 | mustservices
to use the fuji america office you have to be a registered customer, which we are not since we are based in the uk. we cannot go to the uk fuji agent either
Electronics Forum | Thu Jul 20 16:23:08 EDT 2000 | Bob Willis
We set up and ran this process at Nepcon UK with some success but we used a UV adhesive less than 10sec cure so no heat. Push off force for the biggest parts was over 800 grams. We have had to modify the design rules a little to make it work but it
Electronics Forum | Fri Jun 09 09:57:17 EDT 2023 | tommy_magyar
Regardless of what you choose, pay particular attention on the support they offer. Location of manufacturer/distributor office to be in a couple hours of driving distance, so if there is a problem, they can reach you quickly. We use Inertec - no maj
Electronics Forum | Fri Oct 09 15:02:08 EDT 1998 | Bob Willis
| | | I am currently experimenting with Pin-To-Paste reflow. does anyone know some excellent references or links that could give me tips and tricks, optimal aperature dimensions, etc. I have been informed that if I have pull through that I should p
Electronics Forum | Fri Jul 17 06:49:28 EDT 1998 | smd
| Have you tried the TETRA frame with exchangeable stencil foils? | See how the TETRA frame works by looking at www.micromet.co.uk. | The frame to use with the DEK is now available in the U.S. | Call me at (408)562-2033 for more information. | You'l
Electronics Forum | Fri Oct 01 06:28:08 EDT 2004 | Dolby Laboratories
From time to time, component suppliers decide to discontinue production of components that we use in our products. Occasionally, these components can be sourced elsewhere or designs adapted or altered to accommodate alternates. In many cases, however
Electronics Forum | Fri Jun 04 15:43:06 EDT 1999 | JohnW
| | Any of you Process/Manufacturing Engineers, techs, etc..or those of you who 'have a clue' about this stuff been victimized by (clueless and uneducated) Manufacturing Supervisors and (clueless and uneducated) Managers who blame EVERYTHING on YOU,
