Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Mon Feb 27 21:08:21 EST 2006 | ChrisG
I have never seen that message before, but you should check the Z axis driver card, and the Z home sensor. Do you hear anything when the axis tries to move?
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
