Electronics Forum | Wed Nov 11 00:42:15 EST 1998 | Jason
Mike, We retrofitted all of our waves with USI spray fluxers. We are running no-clean on 4 of our waves, and OA 2331-ZX, reduced specific gravity to .825, on the other 2 With OA you must buy a special spray head to accomadate higher pressure and l
Electronics Forum | Sun Feb 08 18:03:26 EST 2009 | davef
Roland What does this thread in the current issue of SMTnet Express newsletter have to do with SMT? Coating Drug-eluting Arterial Stents Using Ultrasonic Spray Nozzles One proven method used to treat clogged arteries employs tubular, mesh-like met
Electronics Forum | Tue Mar 16 14:05:04 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Feb 28 13:13:25 EST 2005 | russ
ING, you had to nake it difficult didn't ya! It appears that all of your parameters are okay. When you state that "sometimes there is a residue" is it liquidous or dry? Is your spray fluxer an ultrasonic or a spray gun head? You may not be getting
Electronics Forum | Wed Nov 27 09:43:17 EST 2013 | mchawg
We recently rebuilt the generator and power supply on our '97 vintage Optiflux Ultrasonic fluxer. That cleared up all its issues except. Ultrasonics are reported by all indicators to be running in both Setup and Run mode, however, the nice rooster-t
Electronics Forum | Tue Mar 16 14:23:44 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 29 16:56:58 EST 1999 | Chrys Shea
| | Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there
Electronics Forum | Mon May 15 14:42:27 EDT 2000 | John Thorup
Hi Sal I've used the Stevens product for about 5 years and have nothing but good to say about them. pallets? can't say. The gloves simply extent the finger length by about 0.04" They come in 15" sticks so the length is up to you. Print/reflow contam
Electronics Forum | Fri Nov 12 05:14:42 EST 1999 | S L CHANG
We are currently cleaning solder paste (TAMURA SQ-1030FP) from stencil using an ultrasonic stencil cleaner with solvent (HYSPER-Non CFC). The process cycle time is 30 sec. cleaning in 1st ultrasonic tank and another 30sec. cleaning in 2nd ultrasonic
Electronics Forum | Mon Mar 15 09:38:30 EST 1999 | Chrys
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
