Electronics Forum | Tue May 25 14:20:47 EDT 2004 | spray fluxing
If you are beginning a new evaluation of fluxes, make sure you consider an ultrasonic spray fluxing system with recipricating head. A fluxer from Ultrasonic Systems can add valuable data to your wave solder process
Electronics Forum | Thu Dec 04 14:31:59 EST 2003 | irun
Hallo We are going to clean PCb after assembly (SMD and THT) due to conformal coating. It is small value production with elements on PCB like BGA, QFP. What you recommend or suggest to use : ultrasonic? , spray wash? or something like dish wash???.
Electronics Forum | Thu Aug 17 15:13:41 EDT 2006 | samir
I hear Pillarhouse is the "Yugo" of Select soldering! :) Chunks et al is correct that if the innards of the fluxing system are made of non-corrosive mat'ls, you should be okay. I used to deal with the original AT&T Spray fluxers and their spray no
Electronics Forum | Tue Dec 28 09:21:22 EST 2004 | pjc
In almost every application an ultrasonic spray fluxer will out perform foam fluxing. Better soldering results are what most expereince after making the change to U/S spray. There are good ultrasonic units from USI and Sono-Tek. www.ultraspray.com w
Electronics Forum | Tue Oct 17 16:07:36 EDT 2006 | tds
Hi Tim (Nopper?), You should not have a cloud of flux comming out of your machine. Is your fluxer a resiprocating fluxer? Is it an ultrasonic spray head? I don't have your contact info any longer due to my laptop meeting my hammer. Send me a p
Electronics Forum | Thu Nov 16 12:52:04 EST 2017 | charliedci
We installed a SonoFlux ultrasonic spray fluxer, replacing the foam fluxer in our Electrovert Econopak wave in 2014. The cost at that time was 16K, installation included. We ran water based flux through it and as long as we kept it clean, worked well
Electronics Forum | Mon Mar 15 20:13:10 EST 1999 | Wayne Bracy
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Wed May 26 10:05:19 EDT 2004 | Cal
Good Point- If you are beginning a new evaluation of fluxes, make sure you consider an ultrasonic spray fluxing system. A fluxer from Sono Tek (www.sono-tek.com) can add valuable data to your wave solder process. regards. Cal *NOTE:I do not receiv
Electronics Forum | Tue Mar 16 14:05:04 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Sun Feb 08 18:03:26 EST 2009 | davef
Roland What does this thread in the current issue of SMTnet Express newsletter have to do with SMT? Coating Drug-eluting Arterial Stents Using Ultrasonic Spray Nozzles One proven method used to treat clogged arteries employs tubular, mesh-like met
.gif)
.gif)
winsouce.jpg)