Electronics Forum | Thu Sep 08 15:17:08 EDT 2016 | bobpan
black on top / blue on bottom both sides good luck
Electronics Forum | Thu Sep 15 11:50:30 EDT 2016 | bobpan
hope this helps
Electronics Forum | Thu Sep 08 13:14:11 EDT 2016 | claudea2
Hello, we have an Ekra E4 that we bought used and the stencil wipe never worked. We found that the air tubing for the up (black)& down (blue) of the wipe roll is missing. There are 2 push connectors for up and 2 for down to receive the tubes. Does an
Electronics Forum | Mon Aug 01 15:11:44 EDT 2022 | proceng1
I have an LX3 Printer from ESE and a US2000 Printer from ESE. What are you using in the tank for the under stencil wipes? IPA or Zextron cleaner or what?
Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Thu Apr 11 19:12:11 EDT 2002 | djarvis
Sorry fellas -disagree. We only clean our stencils in the ultrasonic machine at the end of the run. If the same pcb is up the next day we clean them by hand. We use Electrolube SSS and the used rolls from the in line under stencil cleaner. Wipe the
Electronics Forum | Tue Aug 02 13:47:37 EDT 2022 | emeto
Still using alcohol.
Electronics Forum | Tue Oct 18 10:51:30 EDT 2022 | winston_one
Not only alcohol, there is a special liquids for cleaning of stencils in printers, for example ZESTRON SW. Main is to not confuse it with a liquids for stencil cleaning in cleaning machine. Last one really can damage some parts of machine, and mostly
Electronics Forum | Wed Oct 12 00:42:47 EDT 2022 | kahrpr
You can only use alcohol if you put anything else in the tank it will damage the pump.
Electronics Forum | Fri Feb 11 08:51:45 EST 2000 | HMAL
Dear Masdi, Perhaps you should check again your screen print process. Small amounts of solder paste under stencil can cause your problems. This paste is from previous printed pcb. When printing next pcb this paste attachs to places that it doesn't
