Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads
Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq
Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach
Electronics Forum | Thu Jun 08 01:46:00 EDT 2023 | camilleyang3
To prevent BGA (Ball Grid Array) issues related to SMT (Surface Mount Technology) solder resist when fabricating a PCBA (Printed Circuit Board Assembly), you can follow these guidelines: Design considerations: Ensure proper spacing between BGA pads
Electronics Forum | Mon Jul 08 14:52:40 EDT 2013 | hegemon
The smaller ball "missing" from the lower left is from solder migrating down into the adjacent via. The solder mask may have been damaged or missing prior to mounting the BGA device. The larger balls at the top right are due to uneven heating during
Electronics Forum | Tue May 18 15:36:18 EDT 1999 | Tony
| | | What is the best way to re-ball a BGA? Who has the best system for doing it? | | | | | I'm using our SRT rework stuff to reball in house - when necessary. Of course, we only do this for protos and test boards. We use a standard micro-stencil,
Electronics Forum | Thu Jul 15 10:33:59 EDT 1999 | Michael Zadrejko
| | I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run
Electronics Forum | Wed Jul 14 13:22:51 EDT 1999 | kt
| I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run it
Electronics Forum | Tue May 18 16:48:49 EDT 1999 | Tony
| | | | | What is the best way to re-ball a BGA? Who has the best system for doing it? | | | | | | | | | I'm using our SRT rework stuff to reball in house - when necessary. Of course, we only do this for protos and test boards. We use a standard mi
Electronics Forum | Mon Oct 25 21:49:14 EDT 2004 | davef
First, any results of pull or shear tests are unscientific at best. [We pop our BGA from boards with, appropriately enough, a beverage can opener.] Second, we have no have problems with your ENIG specification. Third, as with your customer, we'd e
Electronics Forum | Mon Aug 17 02:50:44 EDT 1998 | Bob Willis
| Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple
