Electronics Forum | Tue Sep 18 18:03:52 EDT 2007 | fnorradd
Thanks for all of the informations guys, after spending some time rechecking the set ups and checking for worn components in case there was something i missed, i then took some time whilst an operator ran the machine to watch. Whilst doing this i no
Electronics Forum | Thu Nov 18 15:07:27 EST 2004 | valuems
Hello Boy this sure brings back memories from the years past. Was a field engineer for universal for about 9 years. Worked almost exclusively on the Rad 1 and Rad 2. The first thing that I would do is remove the sequencer head that fires at the sa
Electronics Forum | Thu Nov 18 16:57:55 EST 2004 | jdengler
I rebuilt 6348A's for about 13 years. Check the contact at the clip locator. It's dirty, broken, or the wire is starting to come out of the crimp. Jerry
Electronics Forum | Thu Nov 18 13:44:50 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:45:20 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:47:25 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:52:51 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel ma
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Fri Sep 02 09:10:20 EDT 2016 | ttheis
Probably similar cost to find one on ebay or a used machine broker vs. repair unless the fault is obvious from visual inspection. I would be interested to know if anyone does service cards from these older VME chassis though.
Electronics Forum | Mon Oct 13 13:24:21 EDT 2014 | rgduval
Deni, Yep, we found that one the other day, too. And, yes, axis mounted is set to 1. We tried setting it to 0, saving, then back to 1 (again, hoping to clear a software flag/fault, if that's what it is). Thanks, ..rob