Electronics Forum | Tue Jan 09 06:45:08 EST 2018 | micomac
We have Europlacer flexys pick and place. We have had 3 turret collisions with 8mm feeders arising from the tape retaining clip coming free during operation. Have asked Europlacer for part numbers for safety catches that a technician told me existe
Electronics Forum | Mon May 27 12:55:28 EDT 2002 | jgeissler
We are experiencing an increased amount of machine stoppage due to brittle 8mm cover tape. The issue does not appear to be feeder or part/manufacturer specific. Taking a foot of cover tape and pulling it from the ends results the cover tape snappin
Electronics Forum | Tue May 28 17:02:46 EDT 2002 | dougt
I've had problems with this in the past, pretty sure it was due to age. Had a couple of old reels of dummy parts that would not allow for any type of stretching of the cover tape. I have also seen where the cover tape appears to shrink and it pulls
Electronics Forum | Tue Jun 28 20:35:16 EDT 2011 | smellew
Hi you can buy the motors individually direct from Siemens or others suppliers like ourselves SME(Surface Mount Engineering)also many other uk & EU dealers(STM, Adopt, AMS,ISS & CPS, just search you'll find them plus many china suppliers, (Left side
Electronics Forum | Sun Jun 26 21:26:45 EDT 2011 | fholtman
I have a dead motor in one of our triple tracks, one of the three that advance the tape. was just wondering if anyone has been able to order this or any other motors direct or if they all have to come through Siemens. thanks in advance for any replys
Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
