Electronics Forum | Thu Feb 06 04:04:48 EST 2014 | dilogic
I guess this is what you wanted...
Electronics Forum | Thu Feb 06 04:58:04 EST 2014 | escalador
This is just what I was looking for.I dont have the manuals. Many thanks.
Electronics Forum | Thu Feb 06 17:46:33 EST 2014 | escalador
Do You know what is the purpose of slot 12 card, the third one?I it has the fail led on after startup so it cannot pass the machine model loading stage.
Electronics Forum | Thu Feb 06 01:56:53 EST 2014 | aflex
Hey, First you need to check if the I/O port setting is ok. Also how many jumpers are you using? Atlast always connect JP4 to PLD registers base address
Electronics Forum | Mon Feb 10 14:29:01 EST 2014 | dilogic
Sorry, I did not check the forum for a few days. Slot 12 controller is in charge for PWC and Beam1 Head1 (front) theta and Z axes. Which sw. version is installed on your machine?
Electronics Forum | Wed Feb 05 11:39:23 EST 2014 | escalador
Hi, I have an old GSM1 p&p machine unused for some time and I would like to know if someone can give me the correct jumper settings for the 3 Radisys UIMC axis control cards that go on slots 10,11 and 12.Someone modified card positions and I dont kno
Electronics Forum | Mon Sep 10 13:39:21 EDT 2007 | boatwris
I'm sorry to hear that you had a bad experience with Universal. I would like to try to help you. I'm not sure how you tried to contact us, but I'm asking that you e-mail us at universal@uic.com or call us at 1-800-842-9732, and we'll try to help yo
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
Electronics Forum | Fri Oct 09 04:51:49 EDT 2015 | amrsalama
Thanks NRS, yes UIMC by mistake was in incorrect slot (11) once we moved it to slot 12 it works, thanks again.
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
.gif)
