Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Thu Oct 25 19:53:42 EDT 2012 | sonavc
Thank It worked without the user name and password.When I try to zero axis I have other error unable write to global memory 5008. My machine, when turn it on i don't see the power to the Digiplan 8 axis modular and no bright on 24VAC on at servo co
Electronics Forum | Fri Mar 01 10:45:54 EST 2013 | jaimebc
We currently have a problem with our Universal GSM 2. A part ins presented to the front or back camera but there is no image of the component. Just a dark screen, even though the light system is working. Any ideas on what the problem may be? I suspec
Electronics Forum | Thu Dec 07 00:41:19 EST 2006 | bigdaddysoy9
Hello SMTnet, I would like to make a power supply for Universal multi pitch feeders so I can index them offline. How much voltage do I need to get to what pins of the connector? Thanks.
Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Fri Dec 08 08:57:58 EST 2006 | MGC
Hello SMTnet, > > I would like to make a power > supply for Universal multi pitch feeders so I can > index them offline. How much voltage do I need to > get to what pins of the connector? Thanks. http://hoverdavis.com/Products/universal/mpup/uf
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Tue Oct 28 09:23:49 EST 2003 | Gary Camac
We had the same problem recently. It turned out the power supply had a problem. We sent the supply out for repair, but it couldn't be fixed. We found a replacement supply for around $250 that required the drilling of some new mounting holes. This
Electronics Forum | Tue May 30 10:17:07 EDT 2000 | g cronin
I thought I saw that there is a retro kit required to supply the proper power to the multi pitch feeders from older machines. Check the Universal web site for info on the multi pitch I think that is where I read about it...
Electronics Forum | Tue Oct 28 14:03:20 EST 2003 | Bill
Thanks for the help ---one of our test techs checked the power supply and it reportedly is good. Thanks again, Bill
