Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Mon Dec 12 10:38:01 EST 2022 | poly
Cool, I do exactly that, I teach the bottom left and top right corner as it says... though maybe I should try the other ways. It gives me a totally wrong value.
Electronics Forum | Fri Jan 06 08:28:47 EST 2023 | peterm
That's really up to you and for DTF what bank you're using it in so you can reach the pockets for teaching. Obviously easiest to keep them all the same.
Electronics Forum | Tue Jan 03 15:31:51 EST 2023 | griinder
I use a DTF instead of PTF, but one thing I wondered reading this...Which pocket do you designate as "First Pocket" for your tray in your Feeder.db? Could this be affecting the XY position being returned by the machine? For DTF I use upper left. Shou
Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
Electronics Forum | Mon Dec 12 09:41:57 EST 2022 | poly
Thanks Peter, when I open feeder teach i'm presented with a bunch of actions. I can't find docs on what the different actions are. Do you know which one I should do? I have attempted to teach the corners but the value it gives put the PTF pick point
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
