Electronics Forum | Wed Mar 16 22:45:29 EST 2005 | MG Cyr
Thanks for the positive feedback. In addition our standard manufacturing validation, all of our Platform SM products (GSM, Advantis, Genesis etc.)include "on-board" CPK validation and "self calibration". In addition we do have a global relationship w
Electronics Forum | Wed Aug 03 15:35:27 EDT 2005 | mgc
The machine you are buying is probably going to > cost less than the service visit. Then with all > the problems found......hmmmmm....could get real > ugly.......shoulda just bought a new > machine.....hahahhaa " An assessment could suggest tha
Electronics Forum | Thu Mar 23 18:31:31 EST 2006 | Chris
Mike, Have you contacted Universal Instruments yet? If not you should call them. If I am thinking of the same oven, this oven was manufactured by ETS (Energy Technology Systems) or http://www.energytechnologysystems.com. I take it you bought this
Electronics Forum | Wed Apr 12 11:09:55 EDT 2006 | Cmiller
So, you are going to be putting down about 3 million parts a day? How many shifts are you running? At 24 hours a day and assuming the machines never stopped placing parts (which is not possible) you would need a line that put down 125,000 parts an ho
Electronics Forum | Tue Nov 28 08:27:05 EST 2006 | davef
Choices are: * IPC-RB-276 [superseded by IPC-6011/6012], Section 5 discusses some basic shipping and packaging requirements. Also, it references ASTM D-3951 and MIL-P-116. * Universal Instruments has done a nice job putting together a packaging speci
Electronics Forum | Mon Jul 23 11:06:43 EDT 2007 | gmoritz
Steve Thomas: Thank you for the well-written, helpful explanations. Fastek: You must be an accountant. Your advice was totally correct, but of absolutely no use whatsoever. Why even post it? I was basically told; Suprise! You are in charge of o
Electronics Forum | Mon Jul 23 12:31:03 EDT 2007 | gmoritz
Have you tried running it in step mode? Yes, and more. The installer asked me to run a few tests: 1> Intentionally make the machine miss insert a part then put a part in manually to see how the leads align to the cutter head. 2> Push the re
Electronics Forum | Mon Aug 06 11:58:48 EDT 2007 | gmoritz
Do you have BEC (Board Error Correction) > on that machine, and if so, did they > give you the alignment plate for it? I don't know if we have BEC on the machine. I can't even search the 550 page manual that was finally sent to us in a pdf file
Electronics Forum | Mon Aug 06 14:05:02 EDT 2007 | slthomas
BEC hardware would be on the machine as a sensor underneath the placement table, to the left of the C&C, and an emitter attached to a bracket to the left of the insert head. The two line up with each other and the sensor uses a quadrant layout to det
Electronics Forum | Thu Sep 27 16:21:03 EDT 2007 | adlsmt
We have two, about 2.5 years old and 1.5 years old. We run all kinds of parts and get about 18K to 20K CPH. The pick accuracy is fantastic so have saved a lot of $$$$ by not having dump buckets full of parts at the end of runs. I could not be happier
