Electronics Forum | Fri Oct 09 15:23:45 EDT 1998 | Claude Couture
I have trouble loading the executive file into a universal DIP inserter (model 6796 unimod). the start of the loading goes well, but stops at byte 5689. the "run" light stays off. Anybody who knows these machine will know what I'm talking about. I
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Mon Jun 17 15:25:10 EDT 2002 | lysik
I would look at Universal for sure. They have a ton of late model Chip placer's and GSM's that they will discount heavy. There are so many used GSM's and HSP's on the market you could probably get what you need for a fraction of the cost. You could p
Electronics Forum | Mon Sep 23 07:40:17 EDT 2019 | spoiltforchoice
A fair price.... well its the feeders that retain value. I know if you were to sell an Essemtec distributor a machine with say 10 banks of CLM feeders that old, they would give you perhaps only £10k. Refurb CLM feeders are ~£3k gbp (or about 1/2 of n
Electronics Forum | Mon Feb 04 16:29:39 EST 2008 | tonyamenson
I have been trying to eliminate the troublesome tubed parts in our SMT process but because we are a high mix/low-medium volume we still have to deal with it sometimes. However, the ones I can fix I'm working on. The next step in my war against tubes
Electronics Forum | Mon Mar 18 08:48:58 EDT 2024 | spoiltforchoice
200 unique components across an entire range is nothing, Were we all so lucky we would all leave the inventory permanently loaded on the line. The Manncorp machines are probably your cheapest solution new. These chinese machines with western input
.gif)
