Electronics Forum | Sun Dec 31 17:16:37 EST 2023 | ravikumargv
Dear all, We are facing Siemens F5HM machine zero point calibration issue, due to fiducial issue and we need to teach the fiducial position and it's not possible, kindly help us how to teach the zero point fiducial for calibration
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Mon Sep 16 13:21:19 EDT 2013 | larrygroves
yes, in old age Z motors do fail on the machine. also, the spring I am talking about is in the rack assembly. there is a split gear which engages the motor gear and it has a spring which maintains constant engagement with the gear. it is small and
Electronics Forum | Tue Jan 08 14:41:08 EST 2019 | jrogalski88
I am a fairly new technician with a rather large electronics assembly company. Its been an ongoing issue to pick and place small coils using our Universal SMT machines. Curious if any if the seasoned techs at smt.net have any recommendations as far a
Electronics Forum | Sun Sep 18 06:07:52 EDT 2022 | dilogic
Does motor start to move during zeroing at all?
Electronics Forum | Sun Sep 18 06:17:40 EDT 2022 | poly
I'll double check tomorrow but I don't think so, it fails zeroing straight away (without moving the other parts) when the PWC axis is enabled, which is why I tried swapping the board as I assumed it was a controller not being found issue.
Electronics Forum | Sun Sep 18 07:29:22 EDT 2022 | poly
oh great, I'll check that out, can I just swap that between the two machines to check? Is that module on the front of the machine or on the back with the VRM modules? I'm pretty new to finding stuff on the machines!
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Sat Sep 11 08:19:54 EDT 2010 | slwolbert
Greetings: I am having 'Check Servo' issues with an FCP 2 4000. It will zero set but given a few minutes afterwards, the check servo alarm sounds. At times the X/Y table will 'coast' back to beginning position, like the power has been cut to the
