Electronics Forum | Mon Aug 23 20:06:49 EDT 1999 | Peter
I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached t
Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Mon Aug 23 20:56:29 EDT 1999 | Dave F
| I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached
Electronics Forum | Tue Aug 24 15:06:06 EDT 1999 | John Thorup
| | I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attach
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Wed Sep 20 15:56:44 EDT 2006 | Rapid
There is a quick change dedicated tooling solution. It involves a "h-tower" and a machined vacuum (or non-vacuum) plate. There are two 8mm threaded holes on the table that are there for support tooling interface. The tower or tooling bolts to thos
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Tue Sep 05 08:40:33 EDT 2006 | CL
SMAINTECH, Good Morning, We have installed the Gridlock tooling pin with stealth mode on our DEK's. It is a hard tooling pin array that resets the height if the pin for every board. The pin comes up until it comes into contact with something then lo
Electronics Forum | Wed Sep 06 06:12:57 EDT 2006 | jonatf
thanks CL, Any idea how much the Gridlock tooling pin is? Brand new or seconds??? cheers!
Electronics Forum | Tue Apr 28 19:43:25 EDT 1998 | Michael Allen
I'd like to find a buyer for the following used equipment: Make: Universal Instruments Model: 4713D Adhesive Dispenser Options: Rotatable dual-dot head (0deg, 90deg) Price: Asking $4K (No reasonable offer refused) I should note that this d
