Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)
Electronics Forum | Tue Jul 11 18:19:18 EDT 2023 | unsung
You're welcome hope you repay it by helping someone else here.
Electronics Forum | Tue Mar 02 17:41:04 EST 2021 | astarotf
The heads in the middle of production stop and this error appears. We already checked the readers, linear encoders and changed the UIMC cards and found no errors, apparently all these revised parts are working. Can anyone help us where else can we c
Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Wed Mar 03 10:14:45 EST 2021 | spoiltforchoice
I don't have one of these machines, but what kind of checks are you able to do on the linear encoders? On our Essemtec there is a dedicated diagnostic utility that gives you a plot of the encoder readout showing both the raw readout as a sort of roun
Electronics Forum | Wed Jun 28 22:42:34 EDT 2023 | unsung
I work on a few of these Universal machines before. Check your severos ( I believe their 6 of them ) in the back of the machines all of them should be on. If you see a red light on one of them it's gone bad and that's your Y axis card. It's easy to
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
