Electronics Forum | Thu Nov 04 15:11:05 EDT 2021 | azdback
I have an ASYS conveyor that I repaced the motor conmtroller AMC 4-2 with a used one.( Old one lost all power) The used one is in German, and I have not been able to figure out how to change the lenguage to English. This particular conveyor has a mo
Electronics Forum | Tue Dec 21 12:11:06 EST 2021 | jseewald
You likely have raised belly pads. If possible, do a step-up on the thermal pads to compensate for the additional height of the component in this area. Some reduction/adjustment of the gullwing pads may be necessary, so be prepared for a few iterat
Electronics Forum | Wed Dec 08 20:47:01 EST 2021 | cbeneat
It's funny, we expanded with 2 additional lines a few years back. Set them up for exactly what you're saying, the end of one is 5 feet from the beginning of another. Operator would only have to pull the magazine from the mag loader, turn around and l
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Thu Jan 13 22:05:46 EST 2022 | mihai_voivod
-Thank you Thomas. In the past I have tried using a clip to hold it in place and it partially worked as a significant amount of connectors ended up shifted causing defects and necessitating rework. -I am going
Electronics Forum | Wed Dec 29 14:56:41 EST 2021 | babe7362000
I have a problem with SPM machine again when I click the SPM.exe i have a MSG error below "A unexpected error has occurred Windows has run out of resources-20601" I have tried deleting files and have a lot of space yet on the Hard Drive. I'm not s
Electronics Forum | Sat Jan 15 16:45:46 EST 2022 | goseese
I don't seem to be finding any loose connections. I am starting to suspect perhaps the rising table driver, BGE9010C, or the Motor it's self. I just don't know how to prove one or the other. How sensitive to pressure should the table be? While jo
Electronics Forum | Tue Feb 01 16:56:46 EST 2022 | rstellema
Hello all, I have a couple of old FUJI CP-6 SMT placement machines that are operating with very old PCMCIA Flash Memory cards. I would like to insure that I have back-ups should the memory cards fail. I assume that I would need a support USB reader/w
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Wed Mar 16 21:50:25 EDT 2022 | m79d
A few years ago i too was making up some kits, i was cutting resistors,diodes,chokes and only those who have experienced this situation will know how time consuming this simple task can be. I too looked around for some type of machine but couldn't f
.png)
