Electronics Forum | Thu Mar 14 15:26:34 EDT 2024 | gregoryyork
Hi After a little help we are based in England and have a Dage XD6500 Xray which has thrown up a really strange fault which our normal Dage service guy cant find. It says tube error and the error code is a 56 Volts fault from the Tube and cannot star
Electronics Forum | Fri Mar 15 23:09:03 EDT 2024 | erikfriesen
You haven't said what kind of parts you are placing, what is the minimum size component? You might consider multiple machines in line rather than trying to fit this all in one machine, plus this has the advantage of upping throughput. You could get
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Sat May 04 13:06:40 EDT 2024 | erikfriesen
We are using these Cover tape extenders https://smtsupplies.com/products/cover-tape-extenders-8-12mm-yellow-500-per-box The problem we have is that we have on 8mm feeders is that these leaders are harder plastic, and we have to put fishing weights o
Electronics Forum | Fri May 10 01:18:33 EDT 2024 | murtaza
Try using the splice tape without the plastic extension. Use old tape to make the splice. This is much cheaper as well. For the plastic tapes, you have to bend the front a bit during setup and also after running a few boards, stop the machine and
Electronics Forum | Wed May 15 08:06:09 EDT 2024 | james2024
Hi, It's not on your list, but we use an SPI and an AOI from SAKI. Very simple software interface and the same structure on all machines. As soon as the library is set up, a program can be created in a maximum of 20 minutes. The program creation go
Electronics Forum | Wed Mar 01 16:52:43 EST 2000 | Dave F
Hey Hany: Here yago: On power outages: Talk about fun!!!! Can we have more of �em?? � You�re correct that a UPS to run your reflow is very expensive, but all you have to run is the belt motor. That�s "cheap!!!!" Get UPS sizing information from
Electronics Forum | Fri Feb 11 10:14:54 EST 2000 | C.K.
Dave, to answer your questions, point-by-point: � Just out of curiosity, how are second side, skippy components oriented on the board with respect to the wave? The SMD's are all oriented in the "correct" direction with respect to wave direction(i
