Electronics Forum | Mon May 12 11:36:35 EDT 2008 | cyber_wolf
Harry,I know what you mean. You are completely right and justified. My father owns his own business and I see stuff like what you described all of the time. Yes we have done business before. I worked with you when you were with MPM and after you st
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Fri May 02 09:35:20 EDT 2008 | toddl
Hi everyone, I am looking for positive and negative feedback on the use of the paste dispensing system on MPM screen printers. We currently have four machines with this capability that we do not use. Our printer operators insist that the dispensing s
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Tue Nov 18 21:18:29 EST 2014 | sonavc
Thanks, I don't have change to try the Password Now my machine boot up and get " BLUE SCREEN " I screw up my windows NT. Does any one know who till service this machine, reinstall the software and application. I'm in Southern California , CA 92708
Electronics Forum | Thu Nov 06 13:44:15 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Thu Nov 06 13:44:18 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Mon Jul 31 15:32:13 EDT 2006 | cardinal
Question: Can an MPM UP 2000 HI E printer recognize Right or Left justified screens? Please let me know. Brad Jakeway Cardinal Circuit
Electronics Forum | Sat Oct 25 13:36:39 EDT 2014 | sonavc
Hi everyone, hope you can help me with this machine I bought used and after it is set up , it runs good, home position. I can click the tab Start, and Setup. But I can't click the tab I/O , edit or system. Because, I think I can't log in the Level
.gif)
winsouce.jpg)