Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Thu Apr 11 21:20:04 EDT 2013 | dman97
Hello. I am having a problem with a CP3 machine. This machine decides every so often to kill 24v power to its self. At first I thought it was a bad 24V power supply, but I swapped it out and it still decides to occasionally kill its self. I also re
Electronics Forum | Wed Mar 15 04:36:16 EDT 2017 | Rob
@ Sr.Tech, Any voiding means that the part of the package under the void is not forming a solid thermal interface with the PCB, therefore it's heatsinking capability is reduced. With the drive for smaller packages with higher power handling capabil
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Tue May 24 05:25:17 EDT 2005 | Zsolt
We had similar problem, the root cause was that the cooling fans on the VME rack were not working and the vision card hangs up if the temperature is too high. Also check the power supplies, we had also a problem that the filter condensator inside the
Electronics Forum | Tue Aug 22 10:51:49 EDT 2006 | rmitchell
Hi, Hope your machine is back up and running. Are you sure it is not program or PD (part library) related? Try power off and back on and delete the machine program from the machine. Then- Power off and back on and see if the VP error is gone. It
Electronics Forum | Tue Oct 16 18:04:13 EDT 2007 | jmelson
Yeah, getting water into electronics, especially when there is power on, even just battery power, is REALLY bad business. I was rather surprised that you only lost part of the memory if water got up to the board. It may be fixable, but you may have
Electronics Forum | Wed Jun 09 14:41:12 EDT 2010 | ronchap200027
Has anyone had issues with Renco inductors failing. The component I'm having problems with is a 330uH shielded power inductor. Out of 36 board failures, I have 17 that failed because this inductor failed. Most often they end up reading -1.34 uH.
Electronics Forum | Sat Sep 08 16:02:44 EDT 2012 | processman
hi, We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LED`s flash, cognex card intitialises with no error. The issue is we have no fiducial recognition or image on the monitor. Have swapped out camera, cogn
