Electronics Forum | Mon Apr 05 17:47:21 EDT 2010 | boardhouse
Hi Deni, X-ray will not be able to see through Power and Grn planes. Your only way to find out is: 1) ask your board supplier to supply stack up used. 2) surface grind layer by layer to validate if it is correct stack up. What is making you think
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Fri Sep 13 12:06:11 EDT 2002 | simon
Thanks a lot for the reply. The power supply I'm using (12v) is from an HP scanner, so I guess it's always likely that it's not man enough for the job. There were no fuse problems in the car, it just dies. As it is the same problem whether in the
Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.
Electronics Forum | Wed Mar 01 16:52:43 EST 2000 | Dave F
Hey Hany: Here yago: On power outages: Talk about fun!!!! Can we have more of �em?? � You�re correct that a UPS to run your reflow is very expensive, but all you have to run is the belt motor. That�s "cheap!!!!" Get UPS sizing information from
Electronics Forum | Wed Mar 01 16:52:43 EST 2000 | Dave F
Hey Hany: Here yago: On power outages: Talk about fun!!!! Can we have more of �em?? � You�re correct that a UPS to run your reflow is very expensive, but all you have to run is the belt motor. That�s "cheap!!!!" Get UPS sizing information from
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you