Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
Electronics Forum | Wed Sep 24 15:08:13 EDT 2003 | davef
Try: * Excelta Roto-Pic� 2000A [www.excelta.com] * Porta-Wand or Vac-Pac [www.virtual-ii.com] * PELCO� Vacuum Pick-Up System [www.tedpella.com]