Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Oct 09 11:17:24 EDT 2018 | dfl
Ok, I will try and post the result. thanks for the help!
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Tue Oct 09 10:52:57 EDT 2018 | bobpan
re-adjust them .....yes just bend them in a little more. As for led's ....i have tried all kinds...some work better than others.
Electronics Forum | Tue Oct 09 13:15:27 EDT 2018 | dleeper
Bob Wasn't there a MOD code or Function code that controlled default light brightness? My memory is fuzzy on this so I might be completely off base.
Electronics Forum | Wed Oct 10 12:56:26 EDT 2018 | bobpan
ya.....i forgot about that........ mod code 35 and mod code 36 control lighting on the machine. Full brightness is 255. There are also light setting in the configuration file but i tend to keep people out of it. Thanks, Bob
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr
Check your gel flex. They're no good. Don't use em. good Luck pr
