Electronics Forum | Mon Jun 09 14:09:06 EDT 2014 | jorge_quijano
Hola... I'm in the middle of a project to reduce assembly time in one of our products, this product has a lot of TH connectors to be soldered by hand, I'm implementing PHIR, first run has been completed, the appearance of the solder joints are obvio
Electronics Forum | Tue Jun 02 17:32:53 EDT 2015 | jldowsey
Les, Some of the answers to design or stencil aperture/placement machine depend upon what is the current spacing between your components which you didn't specify. Chip components such as 0402's and 0201's typically have very small reductions in pas
Electronics Forum | Thu Sep 26 11:53:40 EDT 2019 | scotceltic
Experiencing some solder balls on an SSO-36 package. Things I am planning on checking are as follows: (not necesarilly in this order) I am just looking for a sanity check to see if you would try other things to help ? 1) Reflow profile. I have he
Electronics Forum | Wed Mar 23 11:40:21 EDT 2022 | SMTA-64388039
In my experience a distance of 30 mils per 1 mil in height above PCA nominal is sufficient for the squeegee blade to bend (in the direction of squeegee travel) so that you don't have excessive solder issues near the label. Labels are about 5 mils ta
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Mon Nov 26 14:49:20 EST 2001 | mparker
1. The formula for cubic area (LxWxH) applies to get the expected volume target value. Caution- do not assume the pad surface square are is correct for the part. Do consider the footprint of the device beign placed and its solder requirements to cre
Electronics Forum | Wed Mar 27 19:26:53 EST 2002 | ianchan
After a whole night's self review, I think we can term the slant/tilt as "floating 0805, yet end-terminals have acceptable solder joint formation". the width portion of the 0805 RES/CAP is (floating)elevated from the PCB pad, yet both (width) termin
Electronics Forum | Tue May 09 22:57:58 EDT 2006 | davef
The NexLev connector is built in a stripline construction, providing a continuous ground plane for each signal contact. The connectors come as tenrow connectors with 100, 200, or 300 positions at possible stacking heights from 10 mm to 30 mm. Technic
Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Tue Dec 04 08:34:07 EST 2007 | davef
We no advice to give you on the topic, but maybe while you're waiting for others to reply, reading a trade journal article on the topic might help. Below is a link to "Pin-in-hole reflow (PIHR) and lead-free solder joints" by David Bernard, Bob Willi
.gif)
.png)
