Electronics Forum | Tue Dec 06 18:29:45 EST 2005 | darby
You may also wish to check the speed controllers for both descent and ascent. The higher the ascent speed the more force the jaws close with. It can be difficult to achieve a "good" nozzle placement height as this is mechanically set and your lowest
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Thu Feb 11 09:45:06 EST 1999 | Dave F
| | | Helo, | | Is it common for actual print height of solder paste to exceed the stencil thickness. For example If the stencil is 6mill thick and the actual height of the print is apx. 10 or 11mill. What causes the paste height to be greater t
Electronics Forum | Wed Jul 13 08:46:15 EDT 2005 | james
Does anyone else have problems with the frameless stencils on the MPM UP2500. I noticed after I do a stencil height adjustment it looks like the vacuum actually pulls the stencil to the board.
Electronics Forum | Thu Jul 14 07:59:33 EDT 2005 | james
The tactile sensor seems to be fine. I think it may have something to do with the stencil being not as tight as to one that is on a stainless steel frame. When we set the height of the stencil we have to do it towards the back of the stencil becaus
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Wed Jan 24 09:52:50 EST 2007 | electronhose
Sounds like you need a support pallet to accommodate the narrow side clearance. Several pallet houses made pallets that work in screen printing that have flush board edge clamps that hold the board in the pallet yet allow the stencil to come all the
Electronics Forum | Fri May 23 05:32:18 EDT 2008 | muarty
Charlie, Anything would be better than using a benchtop printer. We currently run all DEK printers at the moment which are fine, but I've recently been looking into alternatives to the DEK and have been very impressed by the Excerra printer not only
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Mon May 02 11:00:34 EDT 2005 | jh0n!
Unfortunately, we don't have that option under Utilities. Must be UP-2000 specific. I've set everything up correctly, multiple times...All the right dimensions, etc, taught fids, and it still tries to load the board in the wrong position. As far a