Electronics Forum: up500 (Page 1 of 3)

MPM up500 smema issue

Electronics Forum | Wed Aug 31 13:02:36 EDT 2016 | cyber_wolf

Some of the MPM machines have a SMEMA configuration in the software. Not sure about the UP500.

MPM up500 smema issue

Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis

Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.

MPM up500 smema issue

Electronics Forum | Wed Aug 31 17:39:44 EDT 2016 | dekhead

2 on SMEMA end of cable) does it indicate downline available?

MPM up500 smema issue

Electronics Forum | Wed Sep 07 08:52:00 EDT 2016 | dekhead

"Fuji" interface?

MPM up500 smema issue

Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis

I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe

MPM up500 smema issue

Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis

Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.

MPM up500 smema issue

Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis

It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein

Speedline MPM UltraPrint 500 Software

Electronics Forum | Fri Jan 17 03:23:14 EST 2014 | aemery

A UP500 Wow! I did work on one last year. Most left out there are labeled QUAD AVX500's, then Speedline bought Sigmaprint and it became a UP500. But you get the MPM sigpro software with the Speedline machine; they didn't build to many. It was used

Zevatech 730\740 nozzle repair

Electronics Forum | Fri Aug 20 18:52:40 EDT 1999 | Gary Kemp

Would like to find out if the nozzles used with the Zevatech FS730 and FM740 component placers are repairable. In other words, is there a way to get around having to cough up $500.00 per nozzle when one gets damaged? Any insight would be greatly ap

MPM Accuflex

Electronics Forum | Tue Oct 07 15:45:33 EDT 2003 | adlsmt

I believe NEA still sells new UP500's for around $45K. I think MPM dumped them all there and pays them as they sell. Is it worth looking at if the software is upgraded? I had the general opinion that the hardware was not so hot.

  1 2 3 Next

up500 searches for Companies, Equipment, Machines, Suppliers & Information