Electronics Forum | Wed Mar 03 23:07:59 EST 2010 | davef
If your "engineer reviewed the reflow profile and said this was not related to reflow conditions," then what does he think it's related to? We think that a increased effort to improve the thermal recipe to solder this part is required, because: * S
Electronics Forum | Wed Oct 03 09:48:55 EDT 2012 | jimmyboz
I think 29. There is a help key on the televideo kbd, the sticker that says "help" may have fallen off or is now illlegible, its in the upper right of the kbd. I can check for the number if you still have problems
Electronics Forum | Wed Oct 03 10:14:50 EDT 2012 | jimmyboz
I think 29, there is a help key cursor to the area and press the "help" key. It is a sticker on the televideo monitor kby key which may have fallen off or is illegible, its in the upper right
Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Fri Sep 24 14:52:10 EDT 2021 | majdi4
Hello Rainey.. I think that hiden component by the upper shield couldn't be inspected..if the component isn't totally covered by the shield , on can only use the inspection option "missing" by selecting component corners to check only the presence..
Electronics Forum | Thu Feb 11 10:59:09 EST 2010 | sumote
I am having some trouble finding an ESD safe wash basket liner. The trouble isn't finding someone who sells a product, the problem is all 3 products I have evaluated fail testing. All 3 were generators in excess of 2kv with 1 hitting over 4kv! This i
Electronics Forum | Mon Oct 08 05:48:36 EDT 2012 | vinitverma
Dear Chris, N2324 and N2325 are for nozzle down sensors. THese sensors are located on the left and right side of the left and right walls of the head assembly respectively. There are very small holes in the walles through which these sensors transmi
Electronics Forum | Sat Jul 17 10:04:39 EDT 2004 | stefwitt
I think we should shift this issue to the machine suppliers, requesting changes in the machine design, in order to keep at least the jobs of high mix, low volume in this country. We can only compete with low labor cost countries by increasing the lev
Electronics Forum | Tue Sep 12 01:54:57 EDT 2006 | AR
I assume that you are referring to the same kind of mechanical feeders (older type) that are used on the Philips (Assembl�on) Topaz as well. First make sure that the right gear pulley spring is set to its stiffest position (the loop at the end of the
