Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Wed Apr 30 12:40:36 EDT 2014 | tech1
Ok Machine Manufacturers... this goes out to > you. When your Customer (me) spends $150K on a > machine. And you show up at the facility to > install this machine. Please bring the tools you > are going to need to do the basic installation. > As
Electronics Forum | Wed Jun 03 15:45:36 EDT 2015 | ldempsey
Well, it took me a while but I had a look at some gerbers. On a PCB with neighboring 0402's 0.006" apart, and paste reduced 0.75mil on each side, I get lots of bridging. On a later rev of the same PCB, we have neighboring 0402's 0.018" apart,and pa
Electronics Forum | Mon Oct 12 03:09:06 EDT 2015 | akon63
Problem with cleaning these machines is once you > start it's easy to get carried away. ;) > > We > cleaned our SPA-400F a few months ago, had been > offline for a while as we were using our > SPA-250. > > It started as just a clean and to > r
Electronics Forum | Mon May 02 12:28:03 EDT 2016 | adamjs
Why can't you place the entire job the same day you paste it? I can. But setting up and properly cleaning the stenciling machine takes 2-3 hours. We only run one shift. If we do that every day we're spending most the time on setup+teardown. Much
Electronics Forum | Tue May 03 10:32:10 EDT 2016 | swag
Couple idears for you: I've got this error when the program is jacked up, specifically component. In particular from what I remember, GSM or Advantis will give that error when a ball grid array with multiple patterns doesn't add up to a perfect mul
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Wed May 25 10:01:59 EDT 2016 | stevedc
I tend to get issue on and off with the feeders either stalling and/or running slow/noisy. They are actually pretty easy to clean and maintain. If you take off the side panel of the feeder you will see a few gears, belts and a motor. The first thin
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di