Electronics Forum | Thu Oct 31 02:10:44 EST 2002 | fastek
One other thing. Contrary to what Cal suggests, don't buy a warranty from the manufacturer. Unlike the registration, this is a waste of money and is loaded with pitfalls. The best thing you can do is be an informed buyer. Remember, this is not a ca
Electronics Forum | Fri Nov 17 16:24:18 EST 2006 | billwestiet
I'm in North Attleboro, small world. To answer your question, you can deposit small dots of paste with a syringe. Kind of tricky work, and there are small stencil soluions out there fairly inexpensively. See http://www.minimicrostencil.com/ (I do
Electronics Forum | Mon Jan 28 07:34:21 EST 2002 | cnotebaert
Yes, there are a few companies that make de-paneling equipment, Cab is one of the larger they make scoring and tab de-panelers. Just keep in mind regardless to what type of equipment is used if the parts are to close to the board you still run the ri
Electronics Forum | Thu Nov 15 09:12:12 EST 2007 | davef
Post equipment sales on the "Equipment Mart" [use the tab on blue bar, top, left-side of this page]
Electronics Forum | Mon May 21 03:20:16 EDT 2001 | Abbas Izad
you can use IPC and Compact PCI standards for guideline then it depends on what kind of connector you want to pressfit. each supplier has its own design on pressfit pins like "needle eye", "baby H" etc... It is also importand to use proper equipement
Electronics Forum | Thu Jul 09 17:34:19 EDT 1998 | Rob Steltman
| Anybody using this equipment? Got some pros & cons for me? | Thanks in advance. We have 2 Metcal rework stations which we have been using on a daily basis for the last 3 years. I have found them to work very well, although somtimes the replacea
Electronics Forum | Tue Oct 26 10:10:03 EDT 2010 | kapa
We are currently using Mydata (12 and 15) and are now looking at Fuji CP-743 and IP-3, what quality expectation can I have? I am looking for First Pass Yield data from your production with CP-743 and IP-3 machines. Please state type of products you p
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Thu Aug 02 15:27:16 EDT 2012 | davef
Contact several used equipment resellers * ECM Equipment Sales; 4203 S. Purslane Dr; Homosassa, FL 34448; (352)302-8100 ecmsales.com * IBE SMT Equipment , 318 Corporate Woods Dr, Magnolia, TX 77354; (800) 353-6942 (281)259-9660 F(281)259-8863 ibesmt
Electronics Forum | Sat Oct 01 20:31:19 EDT 2011 | assybkr
fishingfool, I would appear obvious that you are connected to Yestech since only inside information could make your statement in paragraph two. I hate to break it to you but a $15,000.00 ransom is exorbitant, most equipment suppliers are half if no