Electronics Forum | Thu Sep 19 16:58:04 EDT 2002 | dragonslayr
You definitely need to have live demos of each system, using your specific assembly if you want to compare apples to apples. Each of the AOI OEM's you mentioned have plus amd minus to their unique systems. You will need to evaluate your specific nee
Electronics Forum | Mon Sep 23 13:08:47 EDT 2002 | dragonslayr
Daan has made a valid point with regards to expertise and use of a machine. Yet I recognize that with advanced technology, trades must occur. A hghly sophisticated AOI unit can and will help reduce overall cost of production. Therefore, a need to ha
Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Fri Aug 03 09:21:08 EDT 2001 | Ian T
hi my company is planing to purchase an aoi system to be used inline. is there anyone out there doing this, if so do you use all the machine options (pattern character recognition, bad board marks, correct part polarity...) or do you dumb it down(pa
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Fri Mar 12 07:22:18 EST 2010 | meritajs
Have anyone bought or used AOI OK600 from DEKTEC AUTOMATION? The company that I work for is looking for reliable low cost AOI system
Electronics Forum | Fri Jun 25 15:39:57 EDT 2010 | tate350
I'd wash them first then AOI. Especially you use the same AOI for WS and no-clean. You certainly will not want any WS flux left inside teh AOI then use the AOI for a NC PCB...
Electronics Forum | Fri Oct 10 05:57:20 EDT 2008 | leeg
Anyone use AOI instead of final inspection for analysing joint quality? If so any good?
Electronics Forum | Fri Jul 10 14:29:58 EDT 2020 | SMTA-64315913
Can you share some information relative to these questions about your conformal coating process: 1) What process controls do you use for conformal coating? 2) Do you perform manual conformal coating inspection? 3) Do you use AOI for inspecting confor