Electronics Forum | Thu Nov 18 08:43:30 EST 1999 | Will Buehler
We currently stuff parts on one side and use a reflow oven. We have been told that many companies are stuffing both sides without high-temp solder or glue. I understand that glue is usually only needed for wave soldering processes. Is it true that
Electronics Forum | Wed Sep 20 04:45:47 EDT 2006 | twentech
Dear O.K. We have for sale: 1. one Siemens feeder 12/16 mm part no. 00141092-04. Can be used for electrical motor. Price: EUROS 150.00 ex warehouse in the Netherlands 2. ten Siemens feeders brand new in original boxes 2x8 mm partno. 00141096-04. Pr
Electronics Forum | Wed Jun 13 15:40:44 EDT 2007 | slthomas
Edited because I completely misinterpreted your post. We used 2 lengths of Durapol with slots for the board edges and a shorty (free-floating, not attached) under the middle. Not much more elaborate than your titanium shims but we had it laying aro
Electronics Forum | Tue Jun 09 10:21:30 EDT 2009 | c111
We have had issues for the last 4-5 years with converting our stock from leaded to ROHS components. We are a CM and have customers who want all ROHS and some that are still leaded. The problems we run into are when we intrduce a new ROHS component wh
Electronics Forum | Wed Sep 08 15:16:50 EDT 1999 | Jason Gregory
| | | Hello: | | | We are using a Heller 1500S reflow oven to solder surface mount parts. Just within the last two weeks, the larger I.C.'s are moving while going through the oven. The parts are checked for placement before putting into the ov
Electronics Forum | Wed Sep 08 17:34:26 EDT 1999 | Earl Moon
| | | | Hello: | | | | We are using a Heller 1500S reflow oven to solder surface mount parts. Just within the last two weeks, the larger I.C.'s are moving while going through the oven. The parts are checked for placement before putting into th
Electronics Forum | Wed Sep 08 20:26:30 EDT 1999 | Jackie Hsieh
| | | | | Hello: | | | | | We are using a Heller 1500S reflow oven to solder surface mount parts. Just within the last two weeks, the larger I.C.'s are moving while going through the oven. The parts are checked for placement before putting int
Electronics Forum | Wed Jun 25 10:29:32 EDT 2003 | caldon
Hey Mike- We ran into the same thing when we purchased a Large CanadianManufacturers repair business. We were creative and first used an ESD bag cut open (Simulate the paper idea) then we used a 3M parts bin and would tip it on its corner to funnel t
Electronics Forum | Wed Jun 13 15:56:35 EDT 2007 | ck_the_flip
I experienced this with a high-mass capacitor. I was able to turn down the bottom-side convection (around 50�C lower than each of the top-side heaters), and able to NOT lose any parts. I got the bottom-side part just slightly over liquidus, and min
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
.png)
