Electronics Forum | Sat Mar 11 08:40:53 EST 2017 | tch
Trish Cantrall is the contact I use for ordering spare parts from ERSA. Private message me if you would like her e-mail address.
Electronics Forum | Wed Oct 06 11:58:33 EDT 1999 | Wolfgang Busko
| | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)
Electronics Forum | Wed Oct 06 20:46:10 EDT 1999 | Mike Cooper
We have same equipment and used the same adhesive. Switched to Loctite 3618 and problem went away. Check cure profile again. 150C at 90s best. Also, check dot size/patterns. Double dots for chips and 4-dot for SOTs works well for us. Regards.
Electronics Forum | Wed Aug 04 18:43:42 EDT 2004 | davef
We agree with you. Since when do failures ask themselves about the process used to attach them to the board, before failing. Smack your colleagues for us!!!
Electronics Forum | Thu Mar 27 11:39:27 EST 2003 | kenlchin
Hi,mantis, I has experienced this case.when we run a model ,misalignment and tombstone of some 0805 resistors and 1206 caps always occured.we have taken many actions,such as adjusting reflow parameter&printing parameter,checking pcb and parts soldera
Electronics Forum | Wed May 22 13:25:45 EDT 2002 | melsolutions
There is a system that Sony uses called Timms. This system has been used worldwide at Sony Electronics manufacturing facilities for over 12 years. They are selling the software package to customers now as a whole full functional product. They have
Electronics Forum | Tue Feb 03 12:39:16 EST 2009 | markhoch
Not sure what your job quantity is, or how many total parts you have to place, but we've had similar issues in the past trying to place domed LEDs. We had better luck cutting the tape into 25 or 50 piece strips and using double-sided tape to put the
Electronics Forum | Thu Jun 25 11:30:18 EDT 2020 | kylehunter
I'd love to see a thread focused on various methodologies used for general inventory management schemes, but primarily on procedures to ensure the proper parts get loaded on the pick and place. We have an Assembleon pick and place, so there is no fe
Electronics Forum | Wed Oct 06 11:41:50 EDT 1999 | Bill Haynes
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
Electronics Forum | Wed Oct 06 08:49:22 EDT 1999 | Mark
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
