Electronics Forum | Fri Jan 21 02:07:16 EST 2011 | obrant
I'm looking for good/clean used chip mounters. juki ke760 yamaha yg100xg panasonic cm202 fuji kikai cp7, 8, 9
Electronics Forum | Sat Jun 07 23:37:34 EDT 2014 | demzvill
Hello all Good morning. I just want to ask with you guys about the problem that we always experienced in our production. We could not get our target ppm due. to inverted placement of chip resistor. We are using 2000 series juki mounter and cf03hp j
Electronics Forum | Tue Jun 10 22:57:18 EDT 2014 | demzvill
Our observation also is that the tape size is too big for the chip which allows the tape to move around. With this i would like to know if there is is a setting in the machine that would slow the feeding rate. We are using juki mounter 2000 series. A
Electronics Forum | Mon May 06 11:50:15 EDT 2019 | sankarseptember
I am using siplace XS Series mounter..I am getting component missing.. atleast one or two per shift production..I wonder this machine don't have option to check at last if any miss or thrown up component.what I need to check? I need any expert in sip
Electronics Forum | Tue May 07 12:50:17 EDT 2019 | sankarseptember
Thanks for the response Thomas..You are correct I got solder paste on both edge on the nozzle type 4007. But it uses for nearly 30 types of part number ..and also I will get missing without any issues in nozzle..I am unable to find the trace in that.
Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
Electronics Forum | Fri Sep 22 07:35:37 EDT 2000 | Henrik Eklund
Hello everyone out there, I have been working in the SMT process for a couple o years now, and now I'm partly responsible for the turret head component mounting process. We are about to buy new equipment and I want to do a capability study of this m
Electronics Forum | Thu Sep 06 20:26:07 EDT 2001 | Eric
We see alot of missing component ( on/off ) after chip mounter, and had check on the component height, is correct. Nozzles had change, vaccume strong enough and table height. But we still have missing component.
Electronics Forum | Thu Sep 06 21:03:29 EDT 2001 | Poon Man
Eric, There are a lot of factors leading to lose components. Suppose your machine works properly. Firstly, is there any gap between the support pins and PCB? If yes, the components may be �dancing� during placement. Have you checked the placement s
Electronics Forum | Fri Jun 23 10:00:08 EDT 2000 | Chrys Shea
Yeah, them soldering machines sure got some demons in them...My waves used to get blamed for wrong polarities all the time. Sneaky little devils used to pull components out of the boards, flip them around, and get the pins back in the holes while
