Electronics Forum | Fri Feb 11 07:13:43 EST 2005 | Daniel Peeters
Hi, I am kind of new in this forum. I would like to know if there exist some SMT manuft. using end of line resistance testing for SMT1206 resistance? If yes do you know possible suppliers? Kind Regards, Daniel Peeters
Electronics Forum | Wed Nov 07 14:41:49 EST 2007 | mainenetservices
We are looking into what equipment would be necessary assemble circuit boards. We will most likely purchase a circuit board and use a pick and place machine to populate the board, and then send through a reflow oven. Then inspect the boards and ass
Electronics Forum | Fri Feb 18 23:13:46 EST 2005 | KEN
My current company used to manufacturer the electronics for coin star. That aside...if you have no intent to sell in Europe you are not affected. But imagine if you (Coin Star)are approached by Europe's largest retailer for 5,000 Kiosks. "Oh", the
Electronics Forum | Thu May 08 21:13:59 EDT 2008 | davef
Glennbrook Technologies Cautionary Note on the Use of Geiger-Mueller Tube Devices: These are inexpensive radiation monitoring devices and it is possible, when they are calibrated to a Cesium-137 standard (at 600 keV), for the meter to read higher tha
Electronics Forum | Fri Sep 18 10:53:37 EDT 1998 | Jim Wilde
I am looking for a small benchtop rework station for replacing bad QFP132's as well as a variety of SO8 to SO20 components and 1206 chips. I've been looking into some IR heating equipment as well as hot air tools, but have little experience with suc
Electronics Forum | Fri May 09 09:25:24 EDT 2008 | russ
Hi Dave, we have thought about it, but would like to have something that we can use anytime we want, The dosimiter badges are good except they have to be sent in and then we wait for results. we have people here that are afraid to even walk in front
Electronics Forum | Mon Apr 30 22:41:29 EDT 2007 | davef
Cross: IPC nor anyone else calls out recommended pressures for washers used to clean circuit boards. IPC and the other standards setting folk are in the business of defining the expected results or outputs of processes or acceptance criterion. They
Electronics Forum | Sat May 10 11:17:14 EDT 2008 | fishingfool
RDR, If you buy a meter you have to send it in once a year to get calibrated at a certified calibration lab. Can be expensive. If you use one that is not certified, and something happens your company will be legally responsible. Major risk. Go
Electronics Forum | Fri Nov 02 17:50:11 EDT 2012 | hegemon
Rather than a catalogue af all the machines and their specs, you might start by defining what YOUR requirements are... some machines are better suited for low mix, high throughput, some better suited for low volume, high changeover rate. Ask yoursel
Electronics Forum | Mon Apr 30 00:49:07 EDT 2007 | Ron Rumrill
Let me chime-in regarding impact pressure. By definition, impact pressure is determined by several factors: 1. The weight of the water (a constant) 2. Its velocity (determined by the GPM and nozzle�s orifice size) 3. The area impinged (determined
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437