Electronics Forum | Tue Jun 23 21:48:06 EDT 2020 | jmelson
I don't know much about Essemtec, I have been looking at Neoden a little. At least the Neoden is not in any way in the same class as machines like Assembleon or Samsung. I did download the manual for a Samsung CP45FV NEO, and the programming side o
Electronics Forum | Mon Jun 22 01:49:27 EDT 2020 | vinitverma
I too would advise against converting a 3-phase machine to single phase. Eclipse is a single phase machine and not too difficult to find! It's a rugged machine and people still use them. Orion too is single phase but faster and less accurate than an
Electronics Forum | Fri Jan 19 04:16:29 EST 2007 | Rob
Hi Steve, Depends where you are in the world too - if in the UK I would go for the Topaz - easier to program & use than the GSM2, if not as good a machine. However there's a lot of 3rd party Quad support if you're in the states.
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Thu Feb 10 14:27:07 EST 2005 | cyber_wolf
First of all, whom are you getting it from ? Mydata, or a used equipment broker. If you can tell me what machine type you are looking at, then I can tell you what to look for. (MY-series, or TP series) Most important things right off the bat: *Machi
Electronics Forum | Thu Feb 10 13:59:35 EST 2005 | bradb
Grant, Thanks for the info. If you are getting rid of your my Data machines please let me know. We are looking at low volume capabilities and your equipment will fit that bill. Please call if your interested in selling the machine. Regards, Brad
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Mon Jun 22 08:23:27 EDT 2020 | jasper
we have 2 machines here Vinit! Emerald 2x
Electronics Forum | Thu Feb 26 16:49:57 EST 1998 | specnor tecnic corp
we have some rebuilt wave soldering systems in stock ready to be shipped. epk-ii smt with lambda wave, chip wave ,omega wave. 4 preheaters,jacking stand roll out computer control. machine is in a great shape. another machin upk15f with 6 preheaters
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437
.gif)
