Electronics Forum | Tue Apr 09 16:19:37 EDT 2002 | Peter L.
Has anyone built using the ALIVH PCB (0402, 0.8mm pitch uBGA) on the SMT line? I would like to know any process issues (paste printing, p&p, reflow) related to processing this pcb. Specifically, what type of solder paste was used (no clean) and wha
Electronics Forum | Mon May 04 10:02:10 EDT 2015 | erinkou
Thanks for sharing with it. I also use it for my PCB orders. And now I recommend http://www.pcbway.com/e, it is a good Fab in China
Electronics Forum | Fri May 11 09:11:05 EDT 2001 | Ian T
hi all i'm looking for a automatic pcb seperator, that uses a knife not a router. i haven't been able to find one one the net. any help whould be appreciated thx ian
Electronics Forum | Fri Jun 26 15:03:26 EDT 2015 | rdengineer
There is a new website to source and see reviews on manufacturers. http://www.vendop.com They have PCB and many other different manufacturing categories as well. I've used them a few times for finding new vendors. Hope it will help.
Electronics Forum | Sat Aug 05 08:08:35 EDT 2006 | rogerw_tech
hi everyone I am doing a research on pcb manufacturing I like to know the process that takes palce in a manufacturing company including the machinery and equipments being used I did a lot searching on the internet but I did not find what I want. t
Electronics Forum | Tue May 15 12:14:25 EDT 2001 | brownsj
If the boards are pre-scored, I've used a system called the CAB Maestro which I found to be a very cost effect piece of equipment. www.cabtechn.com Steve.
Electronics Forum | Fri Nov 07 18:26:05 EST 2003 | jsloot
Is anyone using .062 aluminum circuit boards with copper conductors in your production lines? What kind of reflow profile is required? What special considerations are there to be looking for? I am asking for any information you can give me. Thanks
Electronics Forum | Wed Nov 12 20:03:49 EST 2003 | davef
We used to do this kind of stuff in vapor, but do none now [although the imagination doesn�t have to turn too much to envision doing it again]. Start here: * http://www.bergquistcompany.com * http://www.gouldelectronics.com
Electronics Forum | Tue Sep 01 20:43:06 EDT 2009 | davef
Please explain "adhesion of soldering is not uniform at the tips (soldering ends)." For example: * Is the "tips (soldering ends)" the component leads? * What is the component? * What is the finish on the component? * What process is causing this issu
Electronics Forum | Wed Apr 20 10:09:20 EDT 2011 | accessguy
I have a simple battery powered led array pcb that is turned on and off via rf remote. I want to modify it so that it turns off after 90 seconds, and it flashes or blinks every second or so during those ninety seconds. Can anyone suggest a forum or w
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
winsouce.jpg)