Electronics Forum | Mon May 16 16:40:50 EDT 2005 | russ
Fred, give us a quickie at what you will be soldering Single sided thu hole, double sided SMT, both, lead pitches and protrusions, Flux type, and such. Buying a used wave can be tricky and the more info up front the better we will be able to tell yo
Electronics Forum | Tue Nov 03 18:56:22 EST 2020 | goldendragon
All, I'd like to know what a good used wave pb-free solder machine out there? Appreciates!
Electronics Forum | Mon May 16 15:33:52 EDT 2005 | jasont
Hi Fred, Will you consider used waver solders? I wills end you a list of pre-owned, good working waves that we have in stock. Regards, Jason
Electronics Forum | Mon May 16 16:34:02 EDT 2005 | Fred N
Jason, thx for the reply am definitly looking at used, but was hoping someone would log on to tell me what I should be looking for since i no nothing about the subject.
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Mon May 16 15:22:54 EDT 2005 | Fred N
the company i work for is going into circuit boards and want to find a used wave solder machine theyre budget is 10 to 20 k i have never run one of these machines and dont no what to look for anybody out there have recommendations of what i
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Wed Mar 31 20:49:11 EST 2004 | marcowong
We are trying to buy used double wave solder and ICT machine and we need some advice on selecting the machine and things to be cautious with. It will be greatly appreciated if someone can offer us good suggestions that will help us to minimise mist
Electronics Forum | Wed Mar 31 21:27:00 EST 2004 | marcowong
Dear Darren, Please provide more information of your machine, selling price and where it is at the moment. If it is not in Penang malaysia, please also let us know the transportation cost too. Thank you.
Electronics Forum | Thu Apr 01 08:44:58 EST 2004 | pjc
Be smart, be skeptical and be educated on the machines you are looking at. If you are going to do business with someone you don�t know, check them out. Ask others in your region and get at least ten customer references from them.
.gif)
