Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Oct 29 21:24:30 EDT 2005 | Paul Standeven
The CSM84 family units are 3 headed pick & place machines with mechanical chuck centering technology. They use a beam pointer for fiducial correction. The CSM84V is the same as the CSM84 but has a downward looking fiducial camera onboard in lieu of
Electronics Forum | Wed May 29 15:29:41 EDT 2002 | zanolli
Hello Peterson, If the contact tails protruded enough on the underside of the PCB, then you could do a "reverse" press fit. I do not believe that to be the case with the VHDM. Placement equipment is out of my bailiwick but; Usually small SMT connec
Electronics Forum | Wed Aug 01 15:18:40 EDT 2018 | dleeper
One option might be to convert the coil to through hole and use intrusive reflow AKA pin in paste. the coil leads would have to be formed perpendicular to the board instead of parallel. you would have through holes instead of SMT pads, but you would
Electronics Forum | Mon Jul 06 23:34:30 EDT 1998 | Alan Archer
There is another company by the name of Count on Tools based in Gainesville, GA. Services include: *Diamond Nozzles standard type and special sizes *Adhesive nozzle rework and special design *MPA chuck head parts, rework and calibration *Vacuum pump
Electronics Forum | Fri May 19 08:05:23 EDT 2000 | David
We do a lot of prototype work, builds occur days or months apart and moisture Absorption in IC's is a worry. I would like to bake, chuck in some silica gel and then seal or vac seal in an envelope. Does anyone have any experience of vacuum sealing wa
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Wed Mar 21 17:47:05 EDT 2007 | darby
You need to use the H nozzle and 4 small jaws (1005). Have the slot in the jaws machined towards the rear of the jaw to increase reach. Set up and calibrate that head with that chucking assembly. Always use the same chucking assembly on the same he
Electronics Forum | Wed Mar 21 23:02:04 EDT 2007 | Guest
I did convert YM 84V for 0402, base on my expperience , this approach is not really good.This model were not really meant for 0402 placement. Nozzle H ID is really small and prone to clogging, therefore cleaning every 2 hours is a necessity( not id
